南京科锐达生产销售异形刀片,数控折弯机模具,钨钢分切圆刀片,包装机齿形刀片,纵剪机刀片,分条机刀片,剪板机刀片,切布大圆刀,切粒机滚刀,化纤刀片!

分切圆刀片,折弯机模具,剪板机刀片,切粒机滚刀_南京科锐达撕碎机刀片厂家

撕碎机刀片实力制造商
为企业可持续发展保驾护航

全国咨询热线 138-1309-6959
当前位置:主页 > 技术中心 >

如何调整分条机刀片的间隙

文章出处:未知 人气:发表时间:2019-10-22
  当你使用分条机刀片时,你必须注意一些问题,但是大多数人还不确定。  因此,接下来我们的员工将向您介绍纵切机刀片的调整和使用。
 
  当人们安装新刀片或打磨刀片时,他们会手动调整刀座的高度来调整刀片的切割量,以避免由于新刀片的高度较大而导致切割较深而导致的事故。调节叶片时,人们必须关闭主电机的电源。请等到操作停止。调整时,每个人也应遵循相关步骤。首先,确保切割机处于换刀状态,停止主电机,按下主电机的停止按钮,确认主电机处于静止状态,然后将切割选择开关置于中间换刀位置。然后,大家还要确认刀片的切削深度,用套筒扳手转动皮带轮端面上的螺母,使刀座移动到最低点,观察刀片杆的深度是否合理。如果叶片只有一端与杆接触,那么每个人都可以通过调整主框架后面的偏心轴来解决这个问题。
分条机刀片
 
  When you use the splitter blade, there are some problems that you must pay attention to, but most people are not quite clear. So here we are going to introduce the adjustment and use of splitter blades.
 
  When people install new blades each time, or after grinding blades, everyone must manually adjust the height of the knife bed to adjust the cutting amount of the blade to avoid the deeper cutting caused by the higher height of the new blade. accident, When adjusting the blade, people must turn off the main motor power supply and wait until it stops running. When adjusting, everyone must also follow the relevant steps. First, make sure that the cutter is in the state of changing the knife and stop the main motor., Press the stop button of the main motor to confirm that the main motor is in a stationary state, and then place the cutting selection switch in the middle to change the knife position. Afterwards, everyone must confirm the cutting depth of the blade and rotate the nut on the end of the pulley with a socket wrench. Make the tool bed move to the lowest point, and observe whether the depth of the blade blade is reasonable. If the knife port and the blade touch only one end, then everyone can be solved by adjusting the eccentric axis behind the host frame.

同类文章排行

最新资讯文章